Connected actuator for hydraulic floor heating, Wiser, 230 VAC, connection strip, white

This Schneider Electric Wiser Under Floor Heating is an electrical heating system that requires no wires and no installation. It monitors the temperature of the underfloor heating system to avoid overheating and freezing, humidity of the ambient air to avoid condensation on the floor in cooling mode. Once set up, calibrate the valve by turning the cap. Can add flexible heating control to your house so the temperature is always just right for anyone. It can manage both heating and cooling. Complete the product with a thermostat and a gateway to connect the two. With one equipment you can manage up to 6 rooms. Add up to 3 under flooring heating in big buildings up to 16 rooms. Easy to install by an electrician or a pluber. Identify the clarinet, connect the valve motors to the clarinet and make the room repercussion. The changeover input changes the operating mode from heating to cooling and the valve action is switched. The dimensions are (W) 305 x (H) 90 x (D) 65mm. The degree of protection is IP30. It is a Class II protection device. This double insulated device is not earthed. This device uses normally open relays 2A. The capacity in 3W actuators per device is 14. The rated surge voltage is 4kV. Part 16 0r17. This device allows maximum 3 connection strips per system, maximum 6 zones per connection strip and controls maximum 16 rooms per system. It allows one or several zone per room. The power supply is 230VAC +/- 10% at 50Hz. The radio signal range is up to 30m in open field. The energy class is IV equal to 2%. The device associated fuse rating are 3A and 6A. The wireless frequency is 2.4GHz (Bi-directional, Mesh). The maximum signal strength is +14dBm (25mW). The pollution class is 2. It is a software class A. This product is supplied with an external antenna. The outlet the living room and the system will combine the two. To test the installation, the installer can do it on the product itself for example decide to force the heating in a room and check that the valve will open and that the hot water flows in the right pipe.