DIN rail adaptor KNX SpaceLogic Hybrid Module for KNX and spaceLYnk white

The SpaceLogic KNX Hybrid Module is a device which connects to a Wiser for KNX or spaceLYnk controllers providing them wireless connectivity. It’s compatible with Schneider’s Wiser wireless devices (List of supported devices is constantly growing and may vary from country to country). New or existing KNX installations can be easily upgraded with wireless devices, without the hassle of installing additional KNX cables. Easily, add wireless window/door sensors, motion sensors, water leakage sensor, temperature/humidity sensor to your existing KNX installation. You can add sockets or smart plugs that can be switched on/off remotely. You will be able to control your wireless devices from your KNX devices or vice versa, trigger any KNX device from your Wiser wireless devices. With the new Wiser KNX app, you can control all devices, create schedules, moments (scenes), automations, receive notifications and much more. To properly pair and configure the KNX devices, The SpaceLogic KNX Hybrid plugin, must be installed. It is available for download in the Wiser for KNX and spaceLYnk controller’s marketplace. In a few simple steps, your wireless devices will be paired and configured so they can work as any other KNX device. There is not any different experience when you use wireless or wired device, truly a seamless integration. The KNX Hybrid Module can be powered by the same 24V DC Power supply that powers the Wiser for KNX or spaceLYnk controllers. The communication between the Hybrid Module and the controllers is through a RS232 interface, available in both. The 3m antenna included in the box, is intended for mounting outside of the electrical cabinet, increasing the reach of the wireless signal. Thanks to its magnetic base, it can be placed on any metallic surfaces.The omnidirectional antenna connects to the SpaceLogic KNX Hybrid module through a SMA Male Plug. The KNX Hybrid Module for standard DIN rail, together with the Wiser for KNX or spaceLYnk controllers must be used in the Low Voltage section of the cabinets. If the Antenna cable would run through High Voltage cabinets, the cables must be routed apart from power distribution. Another option is to use a qualified electrical insulating hose. An insulation voltage of at least 2kV is required.