Hexatronic
Lubricant for microducts
- EAN no.: 5709728539490
- LM no.: 7884107902
Must login for adding to cart
Description
Type no: MTV11001/1
Promotion code: 80120325040
UNSPSC (v. 19.0501): 26121630
HS Code: 38231990
Description
Hexatronic Viper Venom is a lubricant for cable installation into microducts. It is especially suitable for micro cable and nano cable installations. The lubricant is non-toxic, easy clean up and non-flammable.
Technical Information
Design: Lubricant for microducts
Capacity:0,24l per bottle
Application
1.Clean and dry the tubing by blowing a tight fitting foam sponge through the microduct with high pressure. If excess water or dirt comes from the microduct, repeat the process. Trapped water can block the air flow.
2.Shake bottle before use.
3.Squeeze recommended amount of lubricant into microduct. Quantity can be measured with a syringe or estimated based on duct fill length (table below).
4.Spread lubricant by blowing a foam carrier or sponge through the microduct as many times as necessary to avoid puddling at the front of the duct.
5.Allow the duct lubricant to dry out completely by blowing in air for at least 5 minutes.
Tube Size OD/ID Lubricant per km Duct Volume required Microduct fill length
16/12mm 29 ml 26 cm
16/10, 14/10, 12/10mm 24 ml 31 cm
10/8mm 19 ml 39 cm
10/6, 8/6mm 14 ml 52 cm
7/5mm 12 ml 62 cm
7/3.5, 5/3.5mm 9 ml 88 cm
Hexatronic Viper Venom is a lubricant for cable installation into microducts. It is especially suitable for micro cable and nano cable installations. The lubricant is non-toxic, easy clean up and non-flammable.
Technical Information
Design: Lubricant for microducts
Capacity:0,24l per bottle
Application
1.Clean and dry the tubing by blowing a tight fitting foam sponge through the microduct with high pressure. If excess water or dirt comes from the microduct, repeat the process. Trapped water can block the air flow.
2.Shake bottle before use.
3.Squeeze recommended amount of lubricant into microduct. Quantity can be measured with a syringe or estimated based on duct fill length (table below).
4.Spread lubricant by blowing a foam carrier or sponge through the microduct as many times as necessary to avoid puddling at the front of the duct.
5.Allow the duct lubricant to dry out completely by blowing in air for at least 5 minutes.
Tube Size OD/ID Lubricant per km Duct Volume required Microduct fill length
16/12mm 29 ml 26 cm
16/10, 14/10, 12/10mm 24 ml 31 cm
10/8mm 19 ml 39 cm
10/6, 8/6mm 14 ml 52 cm
7/5mm 12 ml 62 cm
7/3.5, 5/3.5mm 9 ml 88 cm